Branches of Electronics

By

Electronics has branches as follows.

1- Digital electronics 

2- Analogue electronics

3- Microelectronics

4- Circuit design 

5- Integrated circuits

6- Power electronics 

7- Optoelectronics 

8 - Semiconductor devices

9 - Embedded system

10- Audio electronics

11- Telecommunications

12- Nano electronics

13- Bioelectronics











Comments

Post a Comment

Popular posts from this blog

What is a Capacitor?

By
Image
Capacitor is a passive component that has the ability to store the energy in the form potential difference between two plates. which form to be positive & negative depending upon the direction of charge storage .   Symbol &Unit   - The capacitor symbol is represented by drawing two parallel lines close to each other, but not touching. It consists of two terminals. Standard units for capacitor is Farads. The most common subunits of capacitance are micro farad, nano farad (nF), pico farad (pF) & femo farad(fF) etc.  1 micro farad = 10–⁶ farads 1 nano farad = 10–⁹ farads 1 pico farad = 10–¹² farads 1 femo farad = 10–¹⁵ farads Construction of capacitor  - A capacitor has the  ability to store electric energy in the form of electric field. A non conducting region is present between two plates which is called as dielectric material   (Insulator such as aluminum, paper,air,& ceramic etc). When two plates having same area A, & distance between two pa
Read more

What is rectifier?

By
Image
 A rectifier is an electrical device that converts alternating current (AC), which periodically reverses direction,to direct current (DC),which flows in only one direction.This process is known as rectification. Types of rectifier  - There are mainly three types of rectifier. ( 1) Half wave rectifier  - A type of rectifier that converts only the half cycle of the alternative current (AC) into direct current (DC) is known as half wave rectifier & only require a single diode to construct.   A high AC voltage is applied to the primary side of the step down transformer & it will get a low voltage, which will be applied to the diode. During the positive half cycle of the AC voltage,the diode will be forward biased, for an ideal diode, the forward voltage drop is zero.So the whole input voltage will appear across the load resistance. During the negative half cycle of the AC voltage,the diode will be reverse biased & the current flow
Read more

What is Complementary MOSFET(CMOS)?

By
Image
Complementary Metal Oxide semiconductoris a type of transistor fabrication process that uses complementary & symmetrical pairs of P-type & N-type MOSFET for logic functions . Generally,the CMOS technology is associated with VLSI (Very Large Scale Integrated) circuit,where a few million or even billions of transistors (MOSFETs to be specific) are integrated into a single chip or die. The reasons for the dominant use of CMOS technology in the fabrication of VLSI chips are reliability, low power consumption, considerably low cost & most important scalability . These are four important CMOS process technology (1) N- well process  - In the N-well process,an N-type well or tub is diffused in the P-type substrate. The PMOS transistor M2 is fabricated within this well. The well region acts as the substrate for the PMOS transistor.The additional processing step are the formation on N-region & the ion-imlantation step of P-type source & drain regions.A typical CMOS inverter
Read more